Reply to this topic with questions and answers about Beyond VR products such as Starlight and Starcubes

[This message was edited by Kurt on November 27, 2002 at 01:25 AM.]

solution: if your screen is turning off 15 minutes into your game everytime you play starlight or starcubes, you probably just have the power management turned on.
turn off the power management under windows on the game computer:
- ESC to exit the game menu to the windows desktop
- on the windows desktop choose:
- start
-settings
-control pannel
- power management
- change the settings to read:
system standby: never
turn off monitor: never
turn off hard disks: after 3 hours

If your BVR games cause any of the following things:

- system goes blank the moment BVR tries to load
- system reboots as BVR begins to load
- system crashes as BVR begins to load

then:
check the screen size and color depth. Change to 16bit color at 640x480 and see if that helps.

- you do that by going to the control pannel, under "dispay", under "settings".

Neurocybernetics software version 3.03 or higher
pentium 200mhz.
32 MB ram
RIVA TNT or Mach 64 card or better
windows 98 - (does not work under win xp, but the new pending version does)
CD rom drive
50 free megs
15 megs to store game.

Neurocybernetics System Client Computers:
A. Serial Numbers 2148 & up will run game with no modifications
B. Serial Numbers 2000 through 2147 require upgraded graphics card
C. Serial Numbers 917 through 1999 require Windows 98 and graphics card update
D. Serial numbers 916 and below require game computer upgrade to run this game
E. Serial Numbers 520 and below may require full system upgrade to run this game

Solution: make sure that windows scripting host is enabled under windows setup.
- under control panel / add remove programs / windows setup / accessories / windows scripting host must be installed.